DALI-USB MASTER DALI INTERFACE FOR PC(USB) TO DALI

Tridonic DALI-USB interface serves as a pivotal component for lighting management, bridging USB devices with DALI networks. It facilitates straightforward programming, configuration, and monitoring of DALI lighting systems through a user-friendly software interface. Designed for versatility, it supports a wide range of DALI devices, making it an essential tool for professionals aiming to optimize lighting efficiency and customization in both commercial and residential settings.

MAIN FEATURES

  • PC Interface module from USB to a DALI system
  • For connecting Tridonic software tools
  • Allows addressing, programming of DALI devices
  • For SImple troubleshooting of DALI installations

TECHNICAL SPECIFICATIONS

Device Type DALI-USB PC Interface
Current Draw 6mA from DALI BUS
Control Protocols DALI IEC 60929 and IEC62386
Output Signal DALI

INPUT SPECIFICATIONS

Input Connection 1 x USB (PC Connection)
Screw Connections DALI Line
Power Supply 5VDC (from DALI BUS)
Optional DALI Power Supply DALI-PS

COMPATIBLE SOFTWARE

masterCONFIGURATOR V2.4 AND UP
System Requirements Windows 10+
masterCONFIGURATOR software is used to put DALI circuits into operation via a PC. This software enables device-specific values of DALI operating devices and control devices to be set via DAL

PHYSICAL SPECIFICATIONS

Dimensions 105.5x51x29.5mm
Ambient Temperature T(a) 0 … +50 °C
IP Protection Rating IP20

DALI standard
The DALI USB is designed to control control gear with DALI standard IEC 60929 (DALI V0) and IEC 62386 (DALI V1).

Glow-wire test according to EN 60598-1 passed

The interface module DALI USB is used to connect Personal Computers directly to the DALI network.

This means that complex DALI lighting control solutions can be easily addressed and programmed and that the parameters of the ballasts can be changed.

Note
The connection to the DALI-line is polarity free and protected against overvoltage of up to 270Vac.

 

Wiring type and cross section
The wiring can be in stranded wires with ferrules or solid. For perfect function of the cage clamp terminals the strip length should be 4 – 5 mm for the input terminal. The max. torque at the clamping screw (M3) is 0.2 Nm

To get a proper working strain relief it is recommended that the cable jacket diameter of the side D2 is 2 mm bigger than the diameter of the side D1. (This can vary if the used cable jacket material varies from side D2 to D1 in pinching property).

Data sheet 10/15-CO058-4

Subject to change without notice.

www.tridonic.com